Lake Shore Model 421, Руководство пользователя

Страница: 35 / 92

Lake Shore Model 421 Gaussmeter User’s Manual
Remote Operation 4-1
CHAPTER 4
REMOTE OPERATION
4.0 GENERAL
The Model 421 is equipped with an RS-232C serial computer interface. The interface allows computer
automation of instrument setup and field measurement data collection. Nearly every feature of the
instrument can be accessed through the computer interface. Interface capabilities including setup
information and Basic programs are provided in Paragraph 4.1. Interface commands including a
command summary are described in Paragraph 4.2.
4.1 SERIAL INTERFACE OVERVIEW
The serial interface used in the Model 421 is commonly referred to as an RS-232C interface. RS-232C
is a standard of the Electronics Industries Association (EIA) that describes one of the most common
interfaces between computers and electronic equipment. The RS-232C standard is quite flexible and
allows many different configurations. However, any two devices claiming RS-232C compatibility cannot
necessarily be plugged together without interface setup. The remainder of this paragraph briefly
describes the key features of a serial interface that are supported by the instrument. A customer
supplied computer with similarly configured interface port is required to enable communication.
4.1.1 Physical Connection
The Model 421 has a 9 pin D-Subminiature plug on the rear panel for serial communication. The
original RS-232C standard specifies 25 pins but both 9- and 25-pin connectors are commonly used in
the computer industry. Many third party cables exist for connecting the instrument to computers with
either 9- or 25-pin connectors. Paragraph 6.5 gives the most common pin assignments for 9- and
25-pin connectors. Please note that not all pins or functions are supported by the Model 421.
The instrument serial connector is the plug half of a mating pair and must be matched with a socket
on the cable. If a cable has the correct wiring configuration but also has a plug end, a “gender
changer” can be used to mate two plug ends together.
The letters DTE near the interface connector stand for Data Terminal Equipment and indicate the pin
connection of the directional pins such as transmit data (TD) and receive data (RD). Equipment with
Data Communications Equipment (DCE) wiring can be connected to the instrument with a straight
through cable. As an example, pin 3 of the DTE connector holds the transmit line and pin 3 of the
DCE connector holds the receive line so the functions complement.
It is likely both pieces of equipment are wired in the DTE configuration. In this case pin 3 on one DTE
connector (used for transmit) must be wired to pin 2 on the other (used for receive). Cables that swap
the complementing lines are called null modem cables and must be used between two DTE wired
devices. Null modem adapters are also available for use with straight through cables. Paragraph
6.5.1 illustrates suggested cables that can be used between the instrument and common computers.
The instrument uses drivers to generate the transmission voltage levels required by the RS-232C
standard. These voltages are considered safe under normal operating conditions because of their
relatively low voltage and current limits. The drivers are designed to work with cables up to 50 feet in
length.