laguna PX20, Руководство пользователя

Страница: 28 / 43

28
TROUBLESHOOTING
Description of
Symptoms Possible Cause Corrective Action
Machine will not start
1. Fuse blown or circuit
breaker tripped
2. Cord damaged
3. Not connected to
power source
4. Connected to wrong
voltage
5. Top cover is open
6. Emergency stop
button pressed
7. Overload tripped
1. Replace fuse or reset
circuit breaker
2. Have cord replaced
3. Check connection
4. Check voltage
5. Close top cover
6. Rotate emergency stop
button clockwise until it
pops out
7. Remove lower rear
cover on the base
and press reset
switch found inside
Cutterhead does not
come up to speed
1. Low current
2. Motor not wired for
correct voltage
1. Contact local
electric
company
2. Refer to motor
nameplate for correct
voltage
Workpiece stops when
feeding
1. Too much
material being
removed in one
pass
2. Chipbreaker or
pressure bar set too
low
3. Insufficient
pressure on in-
feed or out-feed
rollers
1. Reduce the
amount of
material being
removed
2. Raise the pressure
3. Increase pressure on
in-feed or out-feed
rollers
Snipe
1. Incorrect setting for
infeed, out-feed
rollers, pressure bar
2. Inadequate support
of long boards
3. Table roller not set
properly
1. Adjust feed system
2. Support long
boards with
extension rollers
3. Adjust table roller
until desired results
are achieved