laguna PX20, Руководство пользователя

Страница: 16 / 43

16
POWER SUPPLY
Power Supply Circuit Requirements
The power source circuit for your machine must be g r o u n d e d and r a t e d f o r
sufficient
a m p e r a g e . Never replace a circuit breaker on an existing circuit with one
of higher amperage without consulting a qualified electrician to ensure
compliance with wiring codes.
If you are unsure about the wiring codes in your
area or you plan to connect your machine to a shared circuit, consult a qualified
electrician.
IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY
GROUNDED. IF YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN CHECK THE
RECEPTACLE.
MOTOR SPECIFICATIONS
The typical main motor is 5 HP and is typically wired for 400-415 Volt, Three Phase, 5 0
HZ, AC current. Confirm your motor electrical configuration before connecting power!
Before connecting the machine to the power source, make sure the starter and switches
are in the "OFF" position. Cord and “plug” are NOT included. These must be installed by
a qualified technician/electrician to local codes.
NOTE: A “plug” and cord are NOT included and must be installed by a qualified
technician/electrician or the power cable connected (hard wired) to an appropriate
disconnect according to local codes. See Wiring Diagram
A qualified electrician should do the connection. When completed, the machine must
conform to the National Electric Code and all local codes and ordinances.
Connecting Power (see Wiring Diagram)
1. Remove screws securing cover to connection box
2. Insert power cable through strain relief, tighten cinch nut and attach wires to
terminals.
3. Re-install the connection box cover
Disconnect power supply to planer before continuing! Only connect power when
required.