laguna PX20, Руководство пользователя

Страница: 23 / 43

23
Adjustment of Infeed Roller
The in-feed roller should be set
0.02” (0.5mm) below the lowest point of knife.
Make sure the knives are set properly see
the “Setting / Changing Knives” section prior
to making any adjustments.
1. Disconnect machine from power source.
2. Place a hard wood gauge (Fig.17, A) under a
knife in cutterhead (Fig.17, B). Place a
0.02” (0.5mm) feeler gauge (Fig.17, C) on top
of wood block and raise table until feeler
gauge contacts the knife in its lowest position.
3. Remove feeler gauge and place wood block
under the left side of infeed roller (Fig.18, D).
The top of wood gauge should just contact
the infeed roller. If it doesn’t, loosen jam nut
(Fig. 18, E) and turn the adjusting screw
(Fig.18, F) to raise, or lower the infeed roller
until it contacts wood gauge then tighten the
nut (E). Repeat for opposite side of the infeed
roller.
Adjustment of Pressure Bar
The pressure bar should be set even with the
lowest point of knife. Make sure the knives are
set properly see the “Setting / Changing Knives”
section prior to making any adjustments.
1.
Disconnect machine from power source.
2. 1. Loosen screw (Fig. 19, 1) and nut (Fig.19,
2) turn the screw to the right so that the
pressure bar moves upward. Place gauge
block and 0.2m/m thickness gauge (Fig.17,
A) under the cutterhead.
3. Place gauge block under pressure bar.
4. Make pressure bar touch the top of the
gauge block.
5. Final, tighten the screw and replace the nut.
Fig. 19: Pressure Bar Adjustment
F
E
D
G
Fig. 18: Roller Adjustment