laguna PX12, Руководство пользователя

Страница: 21 / 38

21
Extension Tables
There are two extension tables, one on the infeed and one on the
outfeed side of the planer (Fig. 11).
1. Lower both extension tables.
2. Place a straight edge on the bed of the planer and extend over the
extension table. The outside “end” of each extension table should
be level with the bed. It is okay for the inner section of the
extension tables to be lower than the main bed. The extension
tables should never be higher than the main bed under the
cutterhead.
3. If adjustment is needed, raise the extension table requiring
adjustment.
Figure 11: Extension Table Adjustment
4. Loosen the lock nut at the bottom of each bolt. Adjust the two
hex head bolts on each side of the extension table either up or
down and check alignment. Make only small adjustments.
5. When the tables align properly tighten the two lock nuts at the
bottom of each bolt.
Extension Table
Adjustment Bolts