17
POWER SUPPLY
Power Supply Circuit Requirements
The power source circuit for your machine must be g r o u n d e d and r a t e d
f o r the am perage given
below. Never replace a circuit breaker on an
existing circuit with one of higher amperage without consulting a qualified
electrician to ensure compliance with wiring codes.
If you are unsure
about the wiring codes in your area or you plan to connect your
machine to a shared circuit, consult a qualified electrician.
Circuit Size
(110V, Single Phase) ........
20 Amp
(minimum)
IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY
GROUNDED. IF YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN
CHECK THE RECEPTACLE.
MOTOR SPECIFICATIONS
The typical main motor is 2 HP and is typically wired for 110 Volt, Single Phase,
60 HZ, AC current. Confirm your motor electrical configuration before
connecting power! Before connecting the machine to the power source, make
sure the switch is in the "OFF" position.
When completed, the machine must conform to the National Electric Code
and all local codes and ordinances.
Connecting Power (See also wiring diagram page 31)
1. Plug cord into dedicated 20 Amp circuit.
Disconnect power supply to planer before continuing! Only connect
power when required.
Содержание PX12
