laguna PX12, Руководство пользователя

Страница: 18 / 38

18
Calibrating the Thickness Scale
Figure 7: Thickness Scale Calibration
NOTE:
The following procedures describe the use of a “calibrating
board”. It is a piece of hardwood which has been surfaced on
one side with a jointer, drum sander or wide belt sander.
1. With the planer OFF, the cutter head not rotating and power
disconnected, place the Calibrating Board on the table, with the
previously machined (flat) face “down”, and slide under the cutterhead.
2. Make sure the Carriage Lock is unlocked (UP position).
2. Use the Table Height Adjustment handle (Fig. 8, A) to raise the table
until the infeed roller is approximately 1/16” above the calibrating
board.
3. Remove the calibrating board from the planer.
4. Connect power to the planer and turn ON.
5. Turn the height adjustment handle clockwise, one complete
revolution, to lower the carriage and run the calibrating board
(previously machined face “down”) through the planer. Lock (“down”
position) the carriage lock.
6. Repeat Step 5 until the planer removes the entire top surface of the
calibrating board.
Thickness Scale
Adjustment Screws
A