laguna 37 x 2, Руководство пользователя

Страница: 9 / 82

General Information 9
OF THE MACHINE.
Additional Safety Information:
1.) KEEP GUARDS IN PLACE and in working order.
2.) REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
3.) KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
4.) DON'T USE IN DANGEROUS ENVIRONMENT. Do not use power tools in damp or wet locations or expose
them to rain. Keep work area well lighted.
5.) KEEP CHILDREN AWAY. All visitors should be kept safe distance from work area.
6.) MAKE WORKSHOP KID PROOF with padlocks, master switches, or by removing starter keys.
7.) DON'T FORCE TOOL. It will do the job better and safer at the rate for which it was designed.
8.) USE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.
9.) USE PROPER EXTENSION CORD. Make sure your Extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord
will cause a drop in line voltage resulting in loss of power and overheating. Table A shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. e smaller the gage
number, the heavier the cord.
10.) WEAR PROPER APPAREL Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry
which may get caught in moving parts. Nonslip footwear is recommended. Wear protective hair covering to contain
long hair.
11.) ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses, they are NOT safety glasses.
12.) SECURE WORK. Use clamps or a vise to hold work when practical. It is safer than using your hand and it
frees both hands to operate tool.
13.) DON'T OVERREACH. Always keep proper footing and balance.
14.) MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
15.) DISCONNECT TOOLS before servicing; when changing accessories, such as blades, bits, cutters, and the
like.
16.) REDUCE THE RISK OF UNINTENTIONAL STATING. Make sure switch is in o position before plugging in.
17.) USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended accessories. The use
of improper accessories may cause risk of injury to persons.
18.) NEVER STAND ON TOOL Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally
contacted.
19.) CHECK DAMAGED PARTS. Before further use of the too., a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function - check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may act its
operation. A guard or other part that is damaged should be properly repaired or replaced.
20.) DIRECTION OF FEED. Feed work into a blade or cutter against the direction of rotation of the blade or cutter
only.
21.) NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Do not leave tool until it comes to a
complete stop.
For three phase models: "The installer shall follow local regulation s and National Electrical Code,
ANSI/NFPA 7 0 installation requirements".