laguna 37 x 2, Руководство пользователя

Страница: 66 / 82

Double Drum Sander 37 x 2 66
starting with the rear drum on dual drum sanders. ***(Follow Steps 1.) through 3.) for the bearing on the left
side of single drum sanders, but do not loosen the rear bolt as instructed in Step 3.)*** .
1.) Begin by:
a.) Removing the outer half of the bearing flange.
b.) Loosen the set screws in the bearing collars.
c.) Remove the bearing
(See Figure 41) .
2.) If the shaft of the drum is rough from the set screws, use emery cloth or sandpaper to smooth down any raised
edges. Slide the new bearing on the shaft, but do not tighten the set screws yet.
3.) Install the outer half of the original bearing flange and tighten the bolts on the rear drum. After tightening the rear
bolt in the flange, loosen it approximately 1/4 turn, which allows the rear drum to pivot. Then tighten the set screw
in the bearing collar
(See Figure 43) .
4. ) Now move to the front drum and repeat Steps 1.) through 3.), but do not loosen the rear bolt as instructed in
Step 3.).