laguna 37 x 2, Руководство пользователя

Страница: 76 / 82

Double Drum Sander 37 x 2 76
side) side of the sander. Loosen the bottom two 3/8" x 1-1/4" bolts from the left drum support casting, but do
not remove them .
5.) Lift the right (inboard) side of drums and place a 2 x 6 on edge under the drums (See Figure 32).
Loosen and remove the V-Belt pulleys from drum shafts.
Important: Make sure to note the location of the pulleys. Also measure the distance from pulley edge to the drum
support casting to use as a reference when reinstalling pulleys so they will be properly aligned.
6.) Loosen the set screws in the two V-belt pulleys and remove the pulleys. Next, loosen the two set screws in
each of the four bearing collars
(See Figure 33) . Now remove the sanding drum support brackets that hold the
bearings (See Figure 34) . Remove the sanding drums currently and install the new drums. If the bearings need
replacing, replace them currently.