Laguna Tools HW110LS-30, Руководство пользователя

Страница: 8 / 37

Serious injury could occur if the machine tips
over .Do not store materials such that it is
necessary to stand on the machine to reach them;
18. CHECK DAMAGED PARTS.
Before further use of the machine, a guard or other
parts that are damaged should be carefully
checked to ensure that they will operate properly
and perform their intended function. Check for
alignment of moving parts, breakage of parts,
mounting, and any other conditions that may affect
its operation. A guard or other parts that are
damaged should be properly repaired or replaced;
19. NEVER LEAVE MACHINE RUNNING
UNATTENDED.
Turn power ‘’OFF’’. Don’t leave any machine
running until it comes to a complete stop;
20. LIGHTING SHALL BE PROVIDED.
A dequate general or localised lighting shall be
provided;
4.2 Specific Safety Instructions for
Sliding Table Saw
1. ALWAYS USE A GUARD.
Always use a guard, splitter and anti-kickback
fingers on all “thru-sawing” operations.
Thru-sawing operations are those when the blade
cuts completely through the work piece as in
ripping or crosscutting.;
2. ALWAYS HOLD THE WORK.
Always hold the work firmly against the miter
gauge or fence;
3. ALWAYS USE A PUSHSTICK OR PUSH
BLOCKS.
Push blocks or push sticks shall be used when
cutting small workpieces and in circumstances
where it is necessary to push the workpiece
against the fence;
4.NEVER.
Never perform any operations “free-hand” which
means using your hands to support or guide the
work piece. Always use either the fence or the
miter gauge to position and guide the work piece;
5.NEVER.
Never stand or have any part of your body in line
with the path of the saw blade;
6.NEVER REACH BEHIND.
Never reach behind or over the cutting tool with
either hand for any reason;
7. MOVE THE RIP FENCE.
Move the rip fence out of the way when
crosscutting;
8. DIRECTION OF FEED.
Feed work into the blade against the direction of
rotation;
9. NEVER.
Never use the fence as a cut-off gauge when you
are cross-cutting;
10. NEVER.
Never attempt to free a stalled saw blade without
first turning the saw OFF;
11. PROVIDE ADEQUATE SUPPORT.
To the rear and sides of the table saw for wide or
long work pieces;