Laguna Tools HW110LS-30, Руководство пользователя

Страница: 13 / 37

Fig.8: Extension wings install
5.4.5 install the rail & fence
A. install the rear rail , front rail, tube,
（
extension
table
）
as breakdown, Before tightening the
fasteners,check to make sure the top edge of rear
rail is flush with the lowest edge of both T-bolts
，
so
the miter gauge will slide smoothly when installed
later. as Fig.9
Fig.9: check the location of rear rail
B, Place the fence on the rails on the right hand
side of blade as Fig.10-2 .
Note:make sure the cam foot contacts the cam
on the fence lock handle before you place the
fence on the rail, otherwise the fence will not
lock into the rail tube. See Fig.10-1
Fig.10-1 Fence assembled
Fig.10-2: fence installed on rails
C, checking fence parallelism (see Fig.11)
----Slide the fence along the rail , if it drags across
the table, then adjust the foot at the rear of the
fence to raise the fence off of the table just enough ,
so that the gap between the fence, and the table is
even from front to back;
----Slide the fence up, against the right hand edge
of the miter slot , and lock it in place ,examine
how the fence line up with the miter slot;