Laguna Tools HW110LS-30, Руководство пользователя

Страница: 16 / 37

with an ultimate tensile strength of 580 N mm-2 or
of a comparable material, have flat sides (within 0,1
mm per 100 mm) and shall have a thickness less
than the width of cut (kerf) and at least 0,2mm
greater than the saw blade plate. As Fig.18
Fig.18
Key:
e riving knife thickness
b saw blade blade
B kerf(width of saw blade cut)
2, The distance of the riving knife from the gear rim
must be between 3mm and 8mm. measured
radially through the centre of the saw spindle. As
Fig.19
Fig.19
3. the highest point of the riving knife must be set
beneath the topmost teeth.
Check that saw blade clamping system is tight
before operating the machine.
5.4.9 Connecting the extraction
system
Dust collector device should be prepared by
customer;
The dust extraction equipment is to be
switched on before commencing machining;
The outlet diameter of is 100mm. Fig.20
Air current speed is 20m/s for vacuum suction dust
emission index, When air current speed of dust
collector device (in accordance with EN
12779:2004) is not lower than 20m/s, ensure
machine can be normal exhausted. User must
wear dustproof mask.
1. Required air flow:1500 m3/h;
2. Ensure pressure drop of each dust collector outlet
carrying air current speed: 1100Pa
3. Wind speed of dust collector tube m/s: dry
chips: 20m/s, water content is equal to18% wet
chips: 28m/s.
Fig.20