5.1.2 Transportation before unpacking
As standard, the machine is packed in a robust
wooden box.
Fig.4
shows the tool can be used to
transport the packing box.
Fig.4
5.2 Unpacking
your machine was carefully packaged for safe
transportation. remove the packaging materials
from around your machine and inspect it. if you
discover the machine is damaged, please
immediately call Customer Service for advice.
save the containers and all packing materials
for possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
5.3 Safety measure before use &
installation
It is important to maintain free area of 0.8 m around
the machine, which is required for the working
place. If any long material is machined, it is
necessary to have a sufficient room in front of the
machine as well behind it in the places of material
input and output.
5.4 installation
Before beginning assembly, take note of the
following precautions and suggestions
----- The machine is bolted to the pallet. Before
attempting any of the assembly procedures
remove all of the loose parts and hardware from
the inside of the machine and unbolt the machine
from the pallet.
-----
FLOOR:
This tool distributes a large amount of
weight over a
small area. Make certain that the
floor is capable of
supporting both the weight of the
machine and the
operator. The floor should also be
a level surface.
If the unit wobbles or rocks once in
place, be sure to
eliminate by using shims.
-----
WORKING
CLEARANCES:
Take
into
consideration the size of the material to be
processed. Make sure that you allow enough
space for
you to operate the machine freely.
-----
OUTLET PLACEMENT:
Outlets should be
located close enough to the machine
so that the
power cord or extension cord is not in an
area
where it would cause a tripping hazard. Be sure
to
observe all electrical codes if installing new circuits
and/or outlets.
DO NOT assemble the machine until you are
certain that the machine is not plugged in and
the power switch is in the OFF position.
DO NOT connect the machine to the power
source until the machine is completely
Содержание HW110LS-30
Страница 26: ...10 Parts List Table Saw Body Breakdown...
Страница 28: ...Trunnion Assembly Breakdown...
