Laguna Tools HW110LS-30, Руководство пользователя

Страница: 19 / 37

6. Adjustment
Before operation, the machine should be
carefully adjusted for best performance. Please
make adjustment as following:
6.1 Blade Raising and Tilting Machine
To raise or lower the blade, loosen lock knob (C)
As Fig.21 and turn the raising handwheel (D).
When desired height is obtained, retighten lock
knob. The blade should be raised 1/8” to 1/4”
above the top surface of the material being cut.
With hollow ground blades the blade should be
raised to the maximum to provide chip clearance.
To tilt the saw blade, loosen lock knob (B) and turn
tilting handwheel (A). When desired angle is
obtained, retighten lock knob. See Fig.21.
Fig.21
6.2 Adjusting Ripfence
1.The rip fence must be perfectly aligned with the
table T-slot, to verify this, align the edge of the rip
fence with the table T-slot and lower the locking
lever (A) Fig.22 to lock in into place. Check to see
if the edge of the rip fence and the table T-slot are
parallel. If they are not parallel, unlock the rip fence
and turn it upside down. Adjust the set screws (H)
as Fig.23 in or out, verify your adjustment, repeat if
necessary.
2.The lock lever pressure can be adjusted by
loosening the front lock nuts (B) as Fig.22 and
adjusting the set screws (C) the same amount,
make sure the fence remains parallel with the table
T-slot. Retighten lock nuts.
3.To set the fence perpendicular to the table, place
a square on the table and against the side of the
fence, loosen the top lock nuts (D) and adjust the
setscrews (E) until the fence is perpendicular.
Retighten lock nuts.
4.The pointer window (F) as Fig.22 position can be
adjusted if needed, loosen pan head screws (G),
reposition the pointer window and retighten pan
head screws.
Fig.22
Fig.23