Laguna Tools 1632, Руководство по эксплуатации

Страница: 12 / 18

-12- www.igmtools.com
TROUBLESHOOTING GUIDE: MOTOR
Problem Possible Cause Solution
Motor does not start
Main power cord unplugged from receptacle Plug in primary power cord
Drum motor cord unplugged from receptacle
near powerfeed motor
Plug in drum motor cord to receptacle on the
machine
Circuit fuse blown or circuit breaker tripped
Replace fuse or retrip breaker (after determining
cause)
Brush motor overloads
Inadequate circuit Check electrical requirements
Machine overloaded Use slower feed rate; reduce depth of cut
Conveyor motor oscillates
Motor not properly aligned
Loosen housing bolts and hex screw holding
the coupler to drive roller
Shaft collar or bushing worn Replace shaft collar or bushing
Drive roller bent Replace drive roller
Drum motor or Conveyor gear motor stalls Excessive depth of cut Reduce depth of cut; reduce feed rate
TROUBLESHOOTING GUIDE: CONVEYOR
Problem Possible Cause Solution
Conveyor drive rollers run intermittently Shaft coupling loose
Align shaft flats of gear motor and drive roller;
tighten shaft coupling set screws
Conveyor belt slips on drive roller
Improper conveyor belt tension Adjust belt tension
Excessive depth of cut Reduce depth of cut; reduce feed rate
Stock slips on conveyor belt causing gou -
ging
Excessive depth of cut Reduce depth of cut Tension rollers too high Lower tension rollers
Excessive feed rate Reduce feed rate
Dirty or worn conveyor belt Clean or replace conveyor belt
Conveyor motor stalls
Belt out of adjustment Readjust belt
Roller bushings elongated due to excessive
wear
Replace bushings
4. Remove the two nuts and washers from outboard (left) side. Lift
the conveyor and remove it from the sander. Set conveyor on motor
side. Avoid tearing the belt on any edges underneath the conveyor
bed during removal. Reverse the procedure for re-installation.
Cleaning the Sander
The sander may need to be cleaned more frequently depending
upon frequency of use. The drum and the conveyor belt need to be
clean. Allowing excess build-up of dust and debris can adversely
affect performance and increase the likelihood of slippage on the
conveyor belt. Sweep the conveyor belt clean after all operations.
When cleaning dust from the drum leave the dust collection system
on.
Optional Accessories:
IGM Fachmann Stick Abrasive Cleaner
Order code: MCBP
IGM LAGUNA 1632 Drum Sander Folding Infeed/Outfeed Tables
Order code: 151-1632FT
Conveyor Belt
IGM LAGUNA Conveyor Belt for Sander 1632 SuperMax
Order code: 151-1632-015
Abrasives
Up to date offer at www.igmtools.com
9. Troubleshooting
Any operating problems will likely occur during the period of
becoming familiar with the sander. If you are experiencing a problem
affecting the machine’s performance, check the following listings for
potential causes and solutions. Also review the previous sections in
this manual on setting up and operating your machine.