Laguna Tools 1632, Руководство по эксплуатации

Страница: 6 / 18

-6- www.igmtools.com
16 A, rating C (16/1/C)). Do not plug the machine into the power supply
until it is fully setup.
6. Setting and Adjustment
6.1 Setting the Drum Sander
Checking Drum Alignment
UNPLUG THE MACHINE FROM THE POWER SOURCE!
During initial setup only. Checking the alignment is necessary to make
sure that the machine functions properly.
1. Before checking the drum alignment make sure that the fast lever
between the conveyor motor and the machine is in the up position
The conveyor table bolts on the inboard side should not be so tight that
the fast lever does not rotate – see first note on page 17.
2. Remove abrasive from the drum. Removing the abrasive ensures that
the adjustment is as accurate as possible.
3. Use a flat, uniform piece of wood as a thickness gauge. Set it between
the conveyor belt and the drum on the inboard (right) side of the machine.
4. The tension rollers are set just below the drum enough so that material
cannot pass easily underneath. Use the height adjustment handle to lower
the head until the drum makes contact with the piece of wood. Turn on the
DRO and take note of the thickness indicated on the display.
6. Screw the height adjustment knob into the handle and tighten it down.
7.+ 8. Slide the digital read-out (DRO) out and install the supplied batteries
with the (+) side facing up.
9. Slide the DRO fully back and plug in the cable from the machine.
Installing Drum Sander (continued)
10. Plug the short power cord that is attached to the motor into the outlet
on the control panel.
11. Make sure that your power supply is adequate (230 V, circuit breaker