Laguna Tools 1632, Руководство по эксплуатации, Страница: 5 / 18

-5- www.igmtools.com
3. Note: Long rail on top of short rail and both rails inside of legs.
4. Connect the second leg sub-assembly to the top long rails.
5. Attach the lower cross braces to the legs. The longer cross braces
should sit on top of the short ones.
6. Attach a levelling foot to the bottom of each leg (not required if installing
optional caster set).
Note: After final assembly and sander installation, adjust the nuts on the
threads as needed to level the stand.
IInstalling Drum Sander
1. For easier access to the machine, peel back the plastic liner, cut the
box at the corners, and fold down the 4 sides of the box.
2. Then with the help of an assistant carefully lift the machine and set it
down on a workbench with one end hanging slightly over the edge.
3. Unscrew the bolts holding the wooden packing support to the underside
of the machine, then carefully turn the machine around and repeat at the
opposite end (these bolts can be re-used to secure the unit to the stand;
extra bolts are also provided for this with the machine).
4. With the help of an assistant place the machine on the stand so that the
mounting holes on the stand line up with the holes on the underside of the
machine. Remove the Styrofoam and wooden support block from under
the sanding head.
5. Using the supplied 14 mm wrench bolt the machine to the stand from
underneath using the supplied hex bolts and washers.
Note: With the machine properly secured, level the stand and tighten all
its bolts.
LIFTING POINT
Drum carriage
LIFTING
POINT
Motor