Laguna Tools 1632, Руководство по эксплуатации

Страница: 4 / 18

-4- www.igmtools.com
Loose sanding belt can cause injury. The workpiece may bounce off the
sanding belt and turn against the machine operator.
Danger of thrown workpiece.
Dust and noise can be health hazards.
Be sure to wear safety goggles, ear protection and dust mask.
Use a suitable dust exhaust system.
Defective or damaged sanding belt can cause injury.
Do not use damaged or worn power cord.
3.4 Grounding Instructions
Connection cord:
In the case of a defect or malfunction, grounding provides a path of least
resistance to electric current, reducing the risk of electric shock. The
machine is supplied with connection cord with a guard wire and euro plug.
The plug must only be connected to an appropriate outlet in accordance
with all local codes and regulations.
• Do not modify the plug, if it does not fit into the socket. Contact a
qualified electrician and have the appropriate socket installed.
• Improper connection may result in a risk of electric shock. Ground wire
is an insulated wire with a green surface with/without yellow stripes. If the
cord or plug needs to be repaired, contact a qualified electrician.
• Damaged cords should be repaired immediately and only by a qualified
electrician.
• Use only three-wire cables with a euro plug and an appropriate socket.
4. Machine Specification
Type: 1632
Power: 230 V / 50 Hz / 1 phase
Recommended circuit breaker: 16 A, rating C (16/1/C)
Current at maximum load: 6,5 A
Power output: 1100 W
Conveyor Belt Motor: 40 W
Speed: 1420 RPM
Feed Speed: 0-3 m/min.
Workpiece Width (one pass): 406 mm
Workpiece Width (two passes): 812 mm
Thickness of Material min. / max.: 0,8-76 mm
Drum Size: 127 x 406 mm
Width of Abrasive: 76 mm
Minimum dust collector capacities: 1000 m3/h
Dust Extraction Outlet: 100 mm
Length x width x height: 860 x 560 x 1220 mm
Weight: 62 kg
Shipping Dimensions: 940 x 660 x 550 mm
Shipping Weight: 71,7 kg
1. Height adjustment handle of the drum
2. Shroud
3. Digital Read-out
4. Knob to start feed conveyor and select feed rate
5. Starts and stops drum motor
6. Conveyor table
7. Tension roller contact adjustment
8. Drum carriage
5. Transport and Setup
5.1 Setup
The machine is transported in a shipping package. The machine is
designed to operate in closed rooms and must be placed stable on a
firm and levelled ground. The machine requires assembling.
Package contents
Stand box contents (found inside the main box)
Drum Sander Assembly
Note: For initial stand assembly secure all bolts finger tight. This will allow
for easier levelling after the sanding unit is installed on the stand. The
holes in the legs are spaced so that the short and long top braces will only
line up from one face of each leg.
1. Secure two legs to the outside of each of the two short top cross braces
using the supplied carriage bolts and flange nuts.
2. Secure the two long top rails inside of the legs and on top of the short
rails.