Lagoon 620, Руководство пользователя, Страница: 55 / 120

ELECTRICITY
ELECTRICITY
4
LAGOON 62O
53
- On the black box on the right (mark B on the photo), mark the diodes
as follows (mark 3, from left to right) :
1 : Portside navigation light
2 : Starboard navigation light
3 : Stern light
4 : Steaming light
5 : Anchorage lights
6 : Masthead light / Deck spotlight
7 : Spreader spotlights
8 : Spotlights on rear beam
9 : Outside soft lights
10 : Three color lights
- Press the button on the right (mark 5) to scroll the diodes up to the
one to be selected.
- Press the button on the left (mark 4) to validate the manual
operation of the selected function.
* To access the "manual override" function of the automatic pilot, its
relay must be shunted.
In order to do this, disconnect the two blue terminals (mark 6) and
then connect them to each other.
2° In case the CPU monitor screen should have a problem, straight
press the Eplex Modules:
(Refer to illustrations on the opposite page)
Access to the Eplex Modules in the cabinet under the chart table.
- Shunt the screen by removing the 6 Ah fuse (mark 1).
- On the black box on the left (mark A on the photo), mark the diodes
as follows (mark 2, from left to right) :
1 : Inside soft lights
2 : Under water spotlights
3 : 24 V electronics: supply for the screens at the helm stations and
chart table, GPM 400.
4 : 12 V electronics: Sea Talk, VHF, camera, ST 70
5 : Radar
6 : Radar
- Press the button under the diode concerned.
When the diode is continuously lit up, the function works.
Please note: when you remove the fuse, the functions that are
multifunction touch-sensitive screen managed turn to OFF and shall
be manually restarted, according to the procedure.