Lagler Flip, Руководство по эксплуатации, Страница: 49 / 64

FLIP
®
01.01.2019
English / Englisch
CAUSES OF FAULTS
• The FLIP ® with short or long attachment has not been handled
with rotary clockwise movements during the sanding
process!
The FLIP ® with corner attachment has not been handled with
counterclockwise movements during the sanding process!
Section 5.1, General application tips
• Too much pressure is placed on the sanding disc during the
sanding process. Do not press too hard on the attachment
during the sanding process.
9.6 SANDING PROBLEMS (WAVES, STRIPS,
GROOVES)
• The floor or stairs were not vacuumed before sanding. The
floor or stairs must be vacuumed thoroughly always directly
before each sanding step.
• The sanding disc was not lifted from the floor while the
machine was switched on or off. Always tilt the machine
backwards slightly before switching the machine on or off
so that the sanding disc is lifted off the floor.
Section 4.3, Switching on the machine
Section 4.4, Switching off the machine
• The machine is being moved too slowly and must be sped
up.
• The FLIP ® with short or long attachment has not been handled
with rotary clockwise movements during the sanding
process!
The FLIP ® with corner attachment has not been handled with
counterclockwise movements during the sanding process!
Section 5.1, General application tips
• The sanding medium does not have the proper tension. The
tension must be corrected.
Section 5.2, Replacing the sanding medium
• The sanding medium is damaged or incorrect and must be
replaced.
Section 5.2, Replacing the sanding medium
• The machine setting angle is not correct. The guide rollers
must be properly adjusted.
Section 7.8, Adjusting the guide rollers
• The wheels are dirty or damaged and must be cleaned or
replaced.
Section 7.9, Replacing the wheels and the guide rollers
9
49