Lagler Flip, Руководство по эксплуатации, Страница: 38 / 64

FLIP
®
01.01.2019
English / Englisch
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7.8 ADJUSTING THE GUIDE ROLLERS
The position of the guide rollers effects the sanding results and
the aggressiveness of the machine.
7.8.1 STANDARD SETTING
The two alignment marks on the universal spanner can be used to
set a position for the guide rollers, which is suitable for both rough
and fine sanding work for the respective attachment.
This is achieved by holding the corresponding alignment mark of
the universal spanner, depending on the attachment used, between
the guide roller and the fan housing and this spacing is then set
(see below for the procedure).
This setting allows a horizontal and even sanding which does not
overload the machine and leads to an even and attractive sanded
finish.
The standing setting of the guide rollers is conducted as follows:
1 Switch off the machine and pull the power plug out of the
socket!
2 Loosen the locknut of the guide roller to be adjusted
(fig. 56, A ).
If the locknut is screwed on too tightly, you can turn the
vertical guide roller axis counterclockwise with the universal
spanner to loosen the locknut (fig. 56, B ).
3 Hold the appropriate universal spanner alignment mark for
the attachment used between the guide roller and the fan
housing. The lettering on the spanner must be legible from
above (fig. 57 and fig. 58).
Alignment marks for the - short attachment: short
- long attachment: long
- Corner attachment: short
4 Now turn the guide roller in the direction required until the
alignment mark on the fan housing and the guide roller match
up (fig. 57 and fig. 58).
5 Retighten the locknut.
6 Adjust the second guide roller.
7
Fig. 57 Standard setting for the short attachment and the
corner attachment .
Fig. 58 Standard setting for the long attachment .
Fig. 56 Undo the locknut on the guide roller.
38