laerdal VitalsBridge 100, Инструкция по применению

Страница: 9 / 45

VitalsBridge Directions for Use
8
rev. A.5
Overview of the VitalsBridge Setup
Upon initial setup, is best to configure the VitalsBridge in stages. Each step is listed below, but is described in detail in
subsequent pages.
Power on the VitalsBridge
•
See page 9 .
Connect Patient Monitor Cables and Sensors to the VitalsBridge
•
Step-by-step instructions start on page 11.
•
Connect your VitalsBridge to your monitor using the pieces of the sensor and cable kit that was included
with your VitalsBridge.
Install the VitalsBridge Connector Software
•
Step-by-step instructions start on page 21.
•
Install the software that sends simulated vital signs from a Windows PC or Android mobile device to the
VitalsBridge.
Establish Communication with the VitalsBridge
•
Step-by-step instructions start on page 24 .
•
Connect to the VitalsBridge using a Windows PC or an Android mobile device.
•
Establish a connection and communicate with the VitalsBridge over Bluetooth, USB, WiFi (VB200 and VB300
only), or Ethernet (VB 200 and VB300 only).
Depending on your simulation equipment and scenario, some additional information may be helpful.
Use the VitalsBridge with a Patient Simulator
•
Step-by-step instructions start on page Error! Bookmark not defined. .
•
Communication between the VitalsBridge and Laerdal simulators is available through the VitalsBridge
Connector software
•
The VitalsBridge can be used with a Standardized Patient