Labconco FlaskScrubber 4110010 Series, Руководство пользователя

Страница: 32 / 108

32

Carefully reinstall the electrical box making sure the slack from the cable does
not interfere with the washer’s internal wiring, the pump fans or the drain valve
linkage. Use cable ties to secure the wire as needed.

Replace the toe kick panel.
Install the Washer
Once service lines are properly connected and the electrical service is off, the washer
can be moved into to its final position. If installing an undercounter model make sure the
mounting tabs at the top of the washer tank are bent out towards the front of the unit. As
you push the unit in place, make sure service connections are not kinked or pinched.
Once in place, verify the unit is level in both directions. The final height adjustment can
be made at this time. Undercounter models must then be attached to the counter top.
Freestanding model’s height can be adjusted to match the adjoining countertop or as
needed. Follow the instructions below to level and secure the washer.
Leveling the Washer

Locate the Allen Wrench used to open the door previously.

Push the Allen Wrench into the hole in the control panel until the door opens.
See Fig 4-1.

Retain the Allen Wrench for emergency access in case of power failure.

Turn the four leveling feet, as needed, to level the washer.
LEVEL IN TWO
DIRECTIONS BY
ADJUSTING
LEVELING FEET
USE SCREWS PROVIDED
TO FIX WASHER TO
COUNTER TOP (2) PLACES
SERIAL TAG
Figure 4-8