La Marzocco vulcano swift, Инструкция по эксплуатации

Страница: 8 / 74

COFFEE DOSE ADJUSTMENT
The coffee dose adjustment must be
done solely by skilled technical
personnel only after disconnecting the
appliance from the power supply by
unplugging.
SET SCREW
COLLAR
IMPELLER
It is possible to change the dosage
quantity by raising or lowering the
height of the impeller.
Proceed as following:
•
remove the tamper window by
loosening the screws;
•
loosen the set screw in the collar of the
tamper shaft coupling.
• holding the tamper shaft coupling in
place, rotate the impeller in the direc-
tion desired. To increase the dosage
amount, turn the impeller clockwise,
as viewed from below. To decrease the
dosage amount, turn the impeller
counter-clockwise, as viewed from
below. Approximately, one 360° turn is
equivalent to 1 gram of coffee.
•
ensure that the set screw is against the
flat side of the tamper shaft. Re-
tighten the set screw in the collar of
the tamper shaft coupling.
Finer adjustment of the dose can be
given by moving the full limit
microswitch. Loosen the microswitch
locking pin. Change the height of the
full limit microswitch by rotating the
setting pin and, once obtained the
optimal position, tighten the locking pin.
MICROSWITCH
LOCKING PIN
MICROSWITCH
SETTING PIN
Before reconnecting the appliance to the
power supply, fix the tamper window in
correct position by relevant screws.
7
EN