La Marzocco Linea PB, Руководство пользователя

Страница: 18 / 112

EN
18
- Place the diffuser screen(s) and diffuser
screw(s) in the solution and leave them
fully submerged for about 30 minutes.
Rinse thoroughly with clean water. Install
and run hot water through each group
several times with the screen installed.
IMPORTANT
If the machine has not been used for more
than 8 hours or, in any case, after long
periods of being idle, in order to use the
machine to its full potential it is necessary
to perform some cleaning cycles before
brewing beverages as follows:
- Groups: with the portafilters engaged
in the groups brew water through each for
at least two minutes
- Being careful to avoid burns, turn on
each steam wand for at least one minute.
- Turn on the hot water valve for the time
necessary to allow the following quantities
of water to be brewed:
At least 1 liter for a 1/2 group machine
At least 2 liters for a 3 group machine
At least 3 liters for a 4 group machine
If the machine is not going to be used
for long periods of time, it is advisable to
follow these safety indications:
- Disconnect the machine from the water
mains or interrupt the water connection
via a mains tap.
- Disconnect the machine from the
electrical mains.
WARNING
IN ORDER TO PREVENT CRACKS OR LEAKAGE: DO NOT
STORE OR INSTALL THE COFFEE MACHINE IN PLACES
WHERE TEMPERATURE MAY CAUSE WATER IN BOILER
OR HYDRAULIC SYSTEM TO FREEZE.
WARNING
IF THE ABOVE-MENTIONED INSTRUCTIONS ARE NOT
ADHERED TO THE MANUFACTURER CANNOT BE HELD
RESPONSIBLE FOR DAMAGE TO PERSONS OR THINGS.
Group
Assembly
Diffusor
Screen
Diffusor
Screw