EN
55
Display
Operating Procedure
Description
Programming Mode
“Barista” Programming
When the espresso machine is turned on, press and hold the T3 button
to access the “Barista”
programming. After about 5 seconds the following screen is displayed.
Move between the parameters using the buttons T1
and T2
until the display shows:
Press the T3 button
to enter the menu.
Press T1
or T2
to select the group whose parameters you want to set.
By pressing the T3 button
the first value will blink. Use the buttons T1
and T2
to reach
the value that you want to set, press T3
to confirm. Repeat this operation to set the second value.
To exit the menu move between the parameters using the buttons T1
and T2
until the exit menu
is displayed. Press the T3 button
to exit the menu.
Press T1
or T2
to continue with the programming of the other parameters.
Press T2
and T3
at the same time to exit the programming mode and return to the normal use
of the espresso machine.
• This parameter allows the operator to
program the time of pre-brewing of
water with the coffee. Each group can
have a different programming.
• Pre-brewing has only two values to be
adjusted for each group. The time (in
seconds) for which the brewing valve
is open during the pre-brewing cycle
and the time (in seconds) for which
the brewing valve is closed during the
pre-brewing cycle; during this time the
pump is active. Once the pre-brewing
cycle is over, the normal brewing cycle
will continue until the end.
• For an espresso machine composed
of three groups, they are identified as
Group 1, Group 2 and Group 3.
Pre-Wet
Settings
Program
Dose
LaMarzocco 00:00
CB 93.8
°
C SB
Pre-Infusion or Pre-Brewing
Pre-Wet
Settings
Group 1 Pre-Wet
0s Wet 0s Hold
Pre-Wet Settings
Exit
LaMarzocco 00:00
CB 93.8
°
C SB
1
2
3
4
5
6
7
Содержание Linea PB
Страница 111: ...EN 111 ...
Страница 112: ......
