EN
7
2) Accessories
Check the package to make sure that the
following accessories are included:
• a number of 1-dose and 2-dose
portailters corresponding to the
number of groups;
• replacement 1-dose and 2-dose ilters
(one of each)
• 1 tamper
• 1 blind ilter
• cleaning detergent, for the groups
• 3 stainless steel braided hoses for
water connections
• 1,5 mt of reinforced plastic tubing for
drainage
• 1 hose clamp
In order to proceed with installation, it is
necessary that the following are available:
• Pipes carrying drinking water with
a
3/8”G (BSP)
end connection;
(3/8”
Compression for USA and Canada)
• Electrical Supply according to the
speciication of the espresso machine
purchased:
• Single/Three phase 220VAC - 50/60
Hz electrical connection with ground,
protected socket and approved
interlock switch
• Single phase 200VAC - 50/60 Hz
100 mm
4 in.
HERE THE POSITION
OF THE POWER CORD
335 mm
13 in.
170 mm
6,7 in.
180 mm
7 in.
HERE THE POSITION
OF THE DRAIN TUBE
160 mm
6,3 in.
160 mm
6,3 in.
WATER INLET HOSES
102 mm
4 in.
80 mm
3 in.
415 mm
16,5 in.
POSITION OF THE HIGH LEGS MACHINE
545mm (2 groups)
21,5 in. (2 groups)
745 mm (3 groups)
29 in. (3 groups)
985 mm (4 groups)
38,5 in. (4 groups)
FROM
∅
100 TO
∅
120 mm
FROM
∅
4 in. TO
∅
4,7 in.
HERE THE POSITION WHERE WE
SUGGEST TO MAKE THE HOLE
ON THE TABLE
250 mm (2 groups)
10 in. (2 groups)
350 mm (3 groups)
13,5 in. (3 groups)
470 mm (4 groups)
18,5 in. (4 groups)
1) Installation on the counter
The image below shows the recommended method to drill the hole on the counter.
Fig. 4 - Installation on the counter
WARNING
IN ORDER TO PREVENT CRACKS OR LEAKAGE:
DO NOT STORE OR INSTALL THE COFFEE
MACHINE IN PLACES WHERE TEMPERATURE
MAY CAUSE WATER IN BOILER OR
HYDRAULICSYSTEM TO FREEZE.
WARNING
AT EACH INSTALLATION, THE MACHINE SHOULD BE
EQUIPPED WITH A NEW SET OF TUBES FOR PLUMBING
AND RELATED GASKETS.
