EN
40
Display
Operating Procedure
Description
“Technical” Programming
1
L a Ma r z o c c o 0 9: 3 0
2
3
4
5
6
7
Press and hold the
button on the group 1 keypad until the following is displayed (approximately 10
seconds)
Enter the 5 digit technician password using buttons 1-5 on the group 1 keypad. Once accepted the following
appears:
Press the
button on the group 1 keypad until the following appears:
Press the
button on the group 1 keypad until the following appears:
Press the
or the
button to change the volume of water required before ilter servicing/replacing
is recommended. When inished press
to conirm.
Press the
or the
button to change the estimated low rate of water. Normally this value should not be
changed. When the desired value is displayed press
to conirm.
When inished, continue to the next parameter
or press
to exit programming mode.
Note:
To reset the function turn off the machine with the
button (press and hold approximately 3 seconds).
Next, press and hold the
button while turning on using the
button.
• This parameter allows the technician
to preprogram an alarm that notiies
the user when the water ilter requires
service or replacement.
• When the programmed volume of
water has passed through the espresso
machine the error message “Change
Filter” is displayed.
• A value of 0 (zero) disables the ilter
alarm parameter.
Filter Alarm
Fi l t er Al a r m
Pa s s wo r d
? ? ? ? ?
La n g u a g e
ENGLI SH
Fi l t e r
Al a r m
Ch a n g e H2 O Fi l t .
0 l i t e r s
Wa t e r Fl o w
12 c c / s e c
