a tone will sound for every second. It is possible that your Projection Alarm may not
be exactly on the second due to the variance in the quartz. However, the clock will
adjust the quartz timing over the course of several days to be very accurate; under .
10 seconds per day.
QUICK SET-UP GUIDE
1) Insert two AA batteries into the Projection alarm and/or plug into wall
2) Wait 10 minutes for WWVB reception.
3) If there is no WWVB reception, manually set the time and date (instructions
in the Program Mode).
4) Program the settings.
5) Mount the WT-5350 in a suitable location, where WWVB signal can be
received.
6) The projector will activate and remain on if the alarm clock is plugged in. If
only batteries are used, the projector will only be activated when a button is
pressed.
7) See the "Features" section for instructions on projection direction, etc.
DETAILED SET-UP GUIDE
BATTERY INSTALLATION
1. Remove the battery cover.
2. Observe the correct polarity and install 2 AA batteries.
3. In addition or instead of inserting batteries, the AC adapter can be used.
Simply plug the adapter into the receptacle on the bottom of the alarm
clock and then plug in adapter.
4. Replace the battery cover.
5. The projector will activate and remain on if the alarm clock is plugged in. If
only batteries are used, the projector will only be activated when a button
is pressed. The projection is a red light, not harmful under normal usage,
although care should be taken to not look directly into the light.
Note:
After the batteries have been installed a tone will sound and the LCD
(Liquid Crystal Display) will activate. The date and U.S. map will be
displayed and the time will appear as "-:--". The WWVB search is
automatically initiated and a tower icon appears and flashes with the
time colon (no tower icon will appear if the WWVB is too weak to be
detected and the time display will remain on "-:--"). While the WWVB
search is being conducted various numbers will appear in the time
display. After 10 minutes, the Projection Alarm will either display the
WWVB time, or discontinue the search if the time is not found. If the
search is cancelled "-:--" will remain in the time LCD. The Projection
Alarm will conduct a WWVB search every hour until the first signal is
found. Once the WWVB time is found, a search is automatically
conducted nightly at midnight. If the signal is found at midnight,
the tower icon will appear. If not, another search will take place every
hour (until 6:00 am) until the signal is received successfully. If no signal
is found during this period, the tower icon will not appear and the clock
will search again at 12:00 am the next night.
PROGRAM MODE
To enter the Program Mode, hold down the "MODE+" button for 2 seconds, until the
time zone ("-5" default) flashes in the lower right. The Program Mode Guide is laid
out in a manner that allows you to program each function separately, or you can
follow the instructions entirely to program the Projection Alarm. Complete
programming is usually done for the initial set-up and will require you to skip step 1
of programming sections C through G. Press the "SNOOZE" button at any time to
exit the Program Mode or wait approximately 15 seconds for the Projection Alarm to
automatically return to normal operation.
AC adapter
receptacle
GB
P.6
GB
P.7
GB
P.8
GB
P.9
