REMOVE BATTERIES FROM THERMOHYGRO AND RAIN
:
While the batteries are out of the display, also remove the
batteries from the Thermo-hygro sensor and the Rain sensor.
Wait 15 minutes.
GENTLY KEY THE WIND SENSOR
: Gently key the wind
sensor one time to activate the sensor.
INSTALL BATTERIES INTO THERMOHYGO AND RAIN
:
Insert fresh alkaline batteries into the Thermohygro sensor and
Rain sensor make sure to check polarity with the markings on
the battery cover and inside the battery compartment. Wait 2
minutes.
INSTALL BATTERIES INTO DISPLAY
: Insert fresh alkaline
batteries into the Display. Make sure to check polarity with the
markings inside the battery compartment.
15 MINUTES
: Wait 15 minutes for the outdoor weather data to
display. If the outdoor data displays dashes after waiting for 15
minutes, repeat steps the restart.
Q:
Intermittent temperature and/or humidity.
A:
RF communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates). If a sensor goes out, please
wait 2-4 hours for it to reconnect on it’s own. Please be patience – these
stations can reconnect on after many hours out.
A:
RF communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
The units try for 20 minutes to reconnect.
After 20 minutes the thermo-hygro stops trying for an hour (to preserve
battery life).
After the 1-hour break, the thermo-hygro sensor will start another 20-
minute re-connect cycle.
A:
Distance/Resistance can cause loss of sensor signal. If possible avoid
having more than 1 wall, window, tree etc., between the display and the
