A:
AVOID:
Transmitting antennas, using PVC pipe (unless electrical grade),
and other sources of interference.
THERMOHYGRO SENSOR:
A:
THERMOHYGRO
: Place the Outdoor sensor vertically, in a well-shaded
area that is protected from direct rainfall and sun.The sensor will read high
if exposed to the sun. If the sensor gets too wet it will not read accurate
humidity. Light incidental exposure to water typically will not harm the
sensor.
A
:
If possible avoid having more than 1 wall, window, tree etc between the
Display and the Thermohygro sensor. UV coated windows may actually
reflect the signal causing loss of contact.
A:
A good location is under the eaves on the north side of the house. You
can also build a small roof or box for it if you do not have an overhang.
Please be sure it is well vented.
A
:
Ideally the Wind & Rain sensors should have a direct line of sight to the
Thermohygro sensor. It is important that all sensors are on the same side
of the house.
A:
It is best to mount the sensor with screws as tape can fail causing the
sensor to fall. Tape is great for positioning until you determine the best
location for your sensor to maintain contact with the display.
A:
NOTE
: Do not place sensor in a plastic bag.
Display
Q:
Program Menu
A:
There are 5 function keys located on the unit: SET, UP ARROW, DOWN
ARROW, ALARM, and MIN/MAX. You begin by pressing and holding the SET
button until the display flashes. When you press and release the SET button
after each step, you will be moved to the next step.
CONTRAST
: Press and hold the SET button. LCD and a number from 1-8
will be flashing. To adjust the Contrast of the LCD display press and
release the UP ARROW or DOWN ARROW button. Press and release the
SET button.
HOUR:
The Hour will now be flashing. Press and release the UP ARROW
or DOWN ARROW button until the correct Hour is shown. WATCH the
AM/PM.
