Basic Operations
36
Basic
Op
er
ation
s
For Macintosh:
Click and drag the [Untitled Folder] folder on the Desktop to the garbage can. If you confirm that
a message ìRemoving safelyî or the like appears, or that the [Untitled folderî does not appear,
disconnect the USB cable and turn off the power switch of the camera.
Cautions to be taken when the PC and the camera are connected
●
Even though you resume your PC from the suspend or sleep mode, you may not be able to
resume communication.
●
When you need to modify an image, such as resizing or rotating, first copy the original image
to your PC, then edit the copied image. DO NOT modify the original. If you modify the stored
data on the memory card directly, you will not be able to view the image on the camera.
●
DO NOT format the memory card using a PC. The memory card may not be able to be used
on the camera.
●
DO NOT delete or move image data directly from the memory card to a PC. If you want to
delete any image data from the memory card, use the DELETE command on the camera.
Uninstalling the USB Driver and Remedies
For Windows 98 and Windows 98SE users, if you have connected the USB cable
before installing the driver software, the driver software is not installed properly.
In this case, take an appropriate remedy following the chart below.
Did you connect the USB cable and turn on the power of the camera before
installing the driver software? Or did the camera stay off?
1
When the power of the camera is turned on
1
Carry out "Removing driver software".
2
Reinstall the driver software. (P.29)
●
If you install the driver software following the procedure on page 29, the window "Pro-
gram maintenance" appears halfway.
Select "Restoration (P)" and proceed installation procedure.
2
When the power of the camera stays off
Remove the USB cable and install the driver software (P.29).
00_8CQ.book Page 36 Wednesday, May 14, 2003 8:10 PM
