Kyocera DF-420, Руководство по обслуживанию

Страница: 64 / 296

3MX
1-5-9
5. Adjust the height of DP.
1) Loosen the nut.
2) For copy example 1:
Loosen the adjusting screw ( ).
For copy example 2:
Tighten the adjusting screw ( ).
3) Tighten the nut.
6. Refit the document processor rear cover.
Figure 1-5-11
Figure 1-5-12
7. Remove the original mat.
8. Place the original mat with its hook and loop
fasteners up over the platen.
Align original mat corner that has 90
degrees of angle with the inner left corner of
the original instruction panel.
9. Close the DP slowly to attach the original
mat.
10. Make a test copy again.
11. Repeat steps 3 to 10 above until the gap of
the trailing edge falls within the reference
values.
Figure 1-5-13
3 mm/4 mm 3 mm/4 mm
Original Copy
example 1
Copy
example 2
Adjusting screw
Nut
Original mat