KYMCO Xciting 250i, Руководство пользователя, Страница: 44 / 92

42
OPERATION
Break-in recommendations
The first 1000 miles (1600 km) of riding are the most impor-
tant in the life of your scooter. Proper break-in operation dur-
ing this time will help ensure maximum life and performance
from your new scooter . Proper break-in operation allows the
machined surfaces to polish each other and mate smoothly .
Your scooter’s reliability and performance depend on special
care and restraint exercised during the break-in period. It is
especially important that you avoid operating the engine in a
manner which could expose the engine parts to excessive heat.
The following guidelines should be followed during the break-
in period:
Maximum throttle operation:
Initial 500 miles (800 km): ........ Less than 1/2 throttle
Up to 1000 miles (1600 km): .... Less than 3/4 throttle
Vary the engine speed:
The engine speed should be varied and not held at a constant
rate for long periods of time. This allows the parts to be "loaded"
with pressure, and then unloaded, allowing the parts to cool.
This aids in the mating process of the engine and transmis-
sion components. It is essential that some stress be placed
on these components during break-in to ensure this mating
process. Do not, however , apply excessive load on the
scooter's drive line.
Avoid constant low speed:
Operating the engine at constant low speed (light load) can
cause parts to glaze and not seat in properly. Allow the engine
to accelerate freely through the gears, without exceeding the
recommended throttle openings.
Avoid using full throttle for the first 1600 km (1000 miles).
The initial service:
Observe your first and most critical service The 600 mile (1000
km) initial service is the most important service your scooter
will receive. During the break-in period all of the engine com-
ponents will have worn in, and all of the other parts will have
seated in, so adjustments will be required. All fasteners will be
tightened, and the contaminated engine oil will be replaced.
NOTE: Completion of the 600 mile (1000 km) initial ser-
vice will ensure optimum service life and performance from
your scooter. Do not delay in having this service performed
once your scooter reaches this mileage.