101
After storage, your UXV500iG requires particular attention and
adjustments to make sure you will enjoy many miles of trouble-
free driving. To take your UTV out of storage, KYMCO recom-
mends using the following procedure:
1. Clean your UTV thoroughly
2. Clean the engine. Remove the cloth from the exhaust system
outlet
3. Check all control wires and cables for signs of wear or fray-
ing. Replace any suspect items
4. Change the engine/transmission oil and filter
5. Charge the battery and test the voltage (refer to page 95)
before installation. When installing the battery, connect the
positive cable first
GENERAL MAINTENANCE
PREPARATION OF YOUR UTV FOR DRIVING AFTER STORAGE
6. Inspect the brake system. Verify the good condition of the brake
fluid, pads and the controls
7. Verify the proper operation and adjustment of all controls, head-
lights, taillight, brakelight - adjust or replace items as necessary
8. Check the tire pressures - inflate the tires to the recommended
pressure
Before installing the battery, make sure the ignition
switch is in the OFF position. Connect the positive
cable to the battery first.
9. Tighten all nuts, bolts, cap screws, and screws - tighten
these fasteners to the proper torque specification. Make sure
that the rivets holding components together are tight - re-
place any loose rivets
10. Make sure the steering moves freely and does not bind
11. Check the spark plug - clean or replace as necessary
12. Follow the recommendations listed in the Pre-Drive Inspection
Содержание UXV500iG
