KYMCO UXV500iG, Руководство пользователя

Страница: 88 / 112

86
GENERAL MAINTENANCE
 
   NOTE: When checking the engine oil level, the UTV should
be parked on level ground with the engine off. Wait approxi-
mately one minute after running for the oil level to stabilize
before checking.
Do not overfill the engine with oil. Overfilling the engine
can cause oil leaks and/or oil contamination of the air
filter element. Always make sure the oil level is above
the "L" mark but not higher than the "H" mark.
Engine Oil Level Inspection
T
o check the engine oil level, use this procedure:
1. Park your UXV500iG on level ground
2. Warm up the engine for several minutes, then turn it off
3. Check the oil level at the inspection window
4. The oil level in the window
1
should be above the "L" mark
but not higher than the "H" mark. Add oil through the filler
cap
2
as required
1 1 1 1 1
2 2 2 2 2
Engine Oil & Oil Filter Replacement
To replace the engine oil and oil filter, and clean the oil strainer
use this procedure:
1. Park your UXV500iG on level ground
2. Warm up the engine for several minutes, then turn it off
3. Place a suitable container under the engine (capable of hold-
ing four quarts of oil)
4. At the bottom of the engine, remove the oil drain plug
3
and
the oil strainer (oil screen) cap
4
to drain the oil
3 3 3 3 3
4 4
4 4 4
When removing the oil screen cap, a compression spring,
oil strainer and O-ring gasket will fall out. Be careful not
to lose these parts and reinstall them in the order that
they were removed. When servicing the engine oil, do
not allow foreign material to enter the crankcase or en-
gine damage may occur.
Procedure continued on the next page