KYMCO 125 DINK -, Руководство по обслуживанию

Страница: 249 / 400

14. DINK 200i:
FUEL SYSTEM (Auto Control Fuel Injection System)
14-7
CHECK ENGINE LAMP (CELP)
! To test check engine lamp operation, the
lamp shall light for a period of 2 seconds
upon “key-on”. This lamp test shall indicate
to the operator that the lamp is functional
and capable of signaling faults should they
occur.
! The operator shall be warned of various fault
conditions that exist within the vehicle using
the CELP. The warning coverage and the
priorities have been detailed in the matrix
below. A fault that activates the CELP with
a lower value priority number takes
precedence over one with a higher value
priority number, i.e. 1 is the highest priority.
! Faults with a level 1 priority shall cause the
CELP to flash.
Faults with a level 2 priority shall cause the
CELP to light continuously.
Faults with a level 3 priority shall not
illuminate the CELP.
! The throttle should be open and hold fully,
then turn the ignition switch ON with no
engine speed, after the “lamp test”
illumination 2 seconds the lamp shall turn
off for 3 seconds. The lamp will then
illuminate for 3 seconds and during this
three seconds interval the throttle mist be
released. The lamp then continues to
illuminate until the first code is flashed.