Chapter 4: Using the web interface
Setting up the interfaces
61
•
Router mode
means the connection will be shared with other users, and the
NAT module of the terminal will make the necessary address translations. Use
this mode if one or more computers are connected using the LAN interface,
and the terminal should act as a router.
•
No Internet access
means no connection to the Internet is allowed. Use this
setting e.g. for the IP handset, where an Internet connection is not required.
The external voice connection is still available; this setting only affects
communication over the Internet.
Also use this setting if you are going to use Group 0 to establish a Bridge mode
connection.
5. Select
Dynamic IP address
.
This is the IP address used externally on the satellite network. Refer to the next
step for Static IP.
6. If you want to use a
static IP address
, you must have it included in your airtime
subscription and use that address as follows:
• Leave the setting in step 5. at
Dynamic
. Do
not
select Static IP.
• Select
SIM default
• Type in the APN user name and password from your provider in step 9.
Your terminal will then use the static IP address set up for your SIM card.
7. Set
IP Header compression
to
Enabled
or
Disabled
.
For information on IP Header compression, see
8. Select the source of the
APN
(Access Point Name).
There are four options for setting the APN. Unless you have special
requirements, it is recommended to use the SIM default, or to set the common
APN to SIM default, and then select Common here. You have the following
options:
•
Common
. The APN is taken from the Common APN defined under
SETTINGS > Common. Refer to
Setting the common interface settings
•
SIM default
. The APN is taken from the SIM card. If you want to use a static
IP address on the external network, select this option either here or in the
Common setting.
•
Network assigned
. The APN is assigned from the network.
•
User defined
. Type in the APN. APNs are provided from the Airtime
Provider.
9. If your APN uses a password, type in the user name and password provided
from the Airtime Provider.
Note
Static IP is handled by the service provider.
Do not type in a static IP
address
in the Static IP address field; a manually typed IP address will
currently not be used by the network.
Note
If you are going to use the static IP address from your SIM card, the user
name and password are mandatory! See step 6. above.
Содержание TracPhone FB150
Страница 1: ...User s Guide TracPhone FB150...
Страница 132: ......
