64
3BA00044-00 • 2013-05-23 • Rev. 4
ersa DIGITAL 2000 A
• Detach soldering iron from the station.
• Pull off cooled tip (pos. 1/fig. 22) and tip mount (pos. 2/fig. 22) from
the heating element. Pull off handle pad (pos. 4/fig. 22).
• Unscrew handle mounting screw (pos. 5/fig. 22).
• Pull off handle (pos. 6/fig. 22).
• Disconnect soldering connection between the heating element (pos.
3/fig. 22) and the connecting wire (pos. 7/fig. 22).
• Change the heating element (pos. 3/fig.22) or connecting lead (pos. 8/
fig. 22).
• Restore soldering connection between the heating element and the
connecting wire (fig. 23).
• Assemble in reverse order.
X-TOOL
When changing the heating elements, proceed as described in the "Ersa
X-TOOL"
Operat
-
ing Instructions (3BA00023-00).
7.
Maintenance and Servicing
7.1
Important care jobs
Note
:
Only use genuine Ersa consumables and spare parts in order to ensure
reliable function and to maintain the unit‘s warranty.
• Make sure that the soldering/desoldering tip is always tinned.
• If required, pierce the soldering/desoldering tip into the dry sponge
prior to desoldering in order to remove used solder and flux residue.
• To obtain good electrical and thermal conductivity, occasionally
remove the soldering tip and clean the heating element shaft with a
brass brush.
• Make certain that the effectiveness of the ventilation holes is not
impaired by a build-up of dust.
Error Diagnosis
and Troubleshooting
/
Maintenance and Servicing
