55
3BA00044-00 • 2013-05-23 • Rev. 4
ersa DIGITAL 2000 A
■
Lift spring hook out of tip hole (pos. 1/fig. 7) and pull off the tip using
the flat-nosed pliers (pos. 2/fig. 7).
■
Set aside the hot soldering tip on a fireproof
support or in the holder.
■
Attach new tip; when sliding on the tip make sure that the knob of the
heating element lies in the slot of the tip (fig. 8). This positions the tip
and prevents turning.
■
Anchor spring hook in the tip hole again.
To obtain good electrical and thermal conductivity, occasionally remove the soldering tip
and clean the heating element shaft with a brass brush.
Changing the soldering tips and
desoldering inserts
The soldering tip and/or the desoldering inserts must be changed if they are worn, or if
a different form of soldering tip or insert is desired. The soldering tip/desoldering inserts
can also be changed when hot:
Figure 9a
Figure 9b
Figure 10
Figure 11
■
Switch the soldering station off, since the heating elements may reach
temperatures of 800 °C without soldering/desoldering insert.
■
Grip the soldering bit/desoldering insert with tip change tweezers and
pull it carefully forwards and off (fig. 9a + 9b).
■
Place the hot soldering/desoldering tip a fire-resistant base. Therefore
we re-commend our special holder SH 03 (fig. 11).
■
Use the tip change tweezers to push the other soldering tip / desol
-
dering inserts up against the spring clamping force until the limit stop
is reached, and align.
■
When changing desoldering inserts only: Use the knurled screw to set
the power limit.
(see chapter 5.5)
■
Switch the soldering station on.
Note
:
The tip exchanger
3ZT00164 is available as an option.
Functional description