KUHN GA 7301, Руководство по сборке и эксплуатации

Страница: 15 / 36

- 13 -
Connect hydraulic hose (H) (photo 7) to the tractor
and activate hydraulics to lift arms (M) until they lock
automatically into the transport position (photo 8).
Install selector plates (L) with 6 self-locking screws
(F) (M 12 x 30) and adjust rod (T) for correct length.
Length is correct when locking pin of handle (E) is
approximately in the middle of one of the elongated
holes of selector plate (L) (photo 8) when the sliding
sections of the lift arms are completely slid into the
arms. Do not forget to tighten lock nuts (I) thereafter.
Then fit guard (B) using 5 hexagon screws (C) (M 8
x 100), 5 self-locking nuts (M 8) and 10 plain washers
(diameter 9 x 22 x 1.5) (place one washer under each
screw and the other under each nut). Make sure that
hoses (U) run through the cut-outs (V) provided in
guard (B) (photo 8A).
Now release hydraulic pressure to lower lift arms (M)
(photo 6).
NOTE : Before fitting guard (B) (photo 8A), do not
forget to set up the electric harness of light
and signal plates (see page 15).
5. Fixation of control cords
(photos 9 & 9A)
Pull one end of the 4500 mm (15') long cords
(I)
through the eyelets (O), the rear side of lock holes
(R) and tie a knot at their front (photo 9).
Thread the other end of cords (
I ) through eyelet (6)
(photos 9 & 9 A).
Slightly tension cords so that they will not be trapped
by revolving rotor arms. Fix on a plastic washer and
tie a knot in front of eyelets (G) (viewed in forward
direction) (photos 9 & 9 A).
Now thread the free ends of the cords (
I
) through the
wooden handle (K) (photo 9 A) and tie knots at the
desired length so that locks can easily be maneuvered
from the tractor cab. Cut off surplus cord.
9
8
8A