KUHN GA 7301, Руководство по сборке и эксплуатации

Страница: 28 / 36

- 26 -
PARKING THE MACHINE
The GA 7301 is equipped with a parking stand (N) to
park the machine in work or transport position.
To park the machine proceed as follows :
- Lower parking stand (N) to vertical position until it is
automatically locked in place by handle (P) (photo
44).
- Lower the tractor 3-point linkage till machine rests on
the parking stand (N).
- Disconnect machine from tractor.
- Place PTO shaft (T) in the PTO support (C) on the
hitch (photo 44).
- Put light and signal plug (F) and male coupling (M)
of the hydraulic hose into their parking supports
(photo 44).
- Fold back side guards (H) and lock them in place
with linch pin (J) (photo 43).
Always park the machine on an area
where the ground is even and fairly
level.
NOTE : The GA 3701 are delivered with a set of 2
wheel sprags (3) (no. 114 6330) which are to
be placed under the carrying frame wheels
when the machine is parked.
Attach holders (1) to the front of the rear
warning board supports (2) with 8 hexagonal
bolts (4) (M 8 x 16) and 8 self locking nuts
(M 8) as shown in photo opposite.
LUBRICATION
Grease the following with SHELL Multi-Purpose grease NLGI grade 2 :
- Every 8 hours of use and at the end of each season : yokes, bearings and drive tubes of the 3 PTO shafts.
- Once a week : rotor housings, tine arm bushings, wheel axle supports and transmission U-joints, pivoting head
stock, guide wheels, steering linkage, pivoting arms and their sliding sections.
Regularly clean and apply a «Never-seize» compound to the removable portion of the tine arms to ensure easy
removal (see fig. 22 on page 16).
Lubricate the following with SHELL X 100 or SAE 90 EP oil :
- As required :
hydraulic cylinder articulations, folding safety guard locks, working width adjustable rods.
- Once a year : check oil level in bevel gearbox (capacity 0.65 litres / 1.14 pints).
TO ENSURE TROUBLE FREE OPERATION OF YOUR MACHINE,
WE RECOMMEND SHELL LUBRICANTS.
44