6. - Putting into service
FC243RGII
39
KN041BGB A
Mower conditioner
6.2.8 Primary PTO shaft
Before using the machine for the first time:
- Grease the transmission.
Check overlap of the u-joint drive shaft and
adjust length if necessary to avoid any
premature wear.
The direction of rotation is shown on a decal.
The tractor PTO stub must rotate at a speed of
540 min
-1
.
- Refer to the decal fitted on the machine
- Separate the two half PTO shafts and connect
them to the machine's input shaft and to the tractor
PTO stub.
- Check the length of the PTO shaft:
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. As a safety measure, a clearance (L)
of at least 25 mm (1’’) must be maintained.
• When the PTO shaft is in its maximum extended
position, the tube overlap must be more than
250 mm (10’’).
540
H
L
If this is not the case:
- Mark length (H) to cut when the transmission is the
maximum overlap position.
- Shorten the guard tubes and the transmission
tubes by the same length.
- Bevel and clean the tubes.
- Grease the inside of the outer tube.
Содержание FC243RGII
Страница 2: ......
