KUHN FC 202, Руководство по сборке и эксплуатации

Страница: 19 / 44

- 17 -
To avoid accidents which could be serious, always check that the safety
guards are firmly in place and to prevent their rotation, attach the free
end of the safety chain to a fixed point (photos 4, 5 & 6). Replace
immediately worn or damaged guards, using genuine KUHN parts.
I. WORKING POSITION
Once at the place of work, the machine
should be lowered to a height of 25 cm
(10") from the ground and changed from
transport to its working position as
follows :
- Release the pivot restraint (M) by
removing locking pin (S) (photo 15).
- Locking pin (S) should then be fitted
in the second hole of the stop (L)
(photo 15).
- Pull cord (E) in order to free position
lock (F) and swing the machine forward
until it locks automatically into the
working position (photo 15).
Never stand between machine
and tractor when swinging ma-
chine from transport to work
position. Make sure there is
nobody between tractor and
machine during this operation.
Lower the machine to the ground and raise
lock (G) to release the spring
compensating system (H) (photo 16).
Adjust the tractor lower link arms (W &
W’) (photo 6, page 15) if necessary so
that the chassis of the 3-point frame is
parallel to the ground.
Raise the hydraulic lift linkage so that
the lower right-hand link pin is
approximately 50 cm (20") above the
ground. Connect the support chain (B) in
the highest possible hole position of
the attachment bracket (T) of the
tractor (photo 16).
Completely lower the tractor linkage.
Lenght adjustment is correct when :
- The cutterbar is resting on the ground.
- The chain (B) is tight.
- T h e r i g h t - h a n d l o w e r l i n k i s
approximately 45 cm (18") from the
ground.
- The 3-point frame is horizontal and
vertical (square tube ‘K’).
- The left-hand lower link (I) is
approximately 55 cm (22") from the
ground.
Attention : Close the eye of support
chain (B) using roll pin
(photo 16).
WORKING POSITION AND ADJUSTMENTS