KUHN FC 202, Руководство по сборке и эксплуатации

Страница: 23 / 44

- 21 -
I. TRANSPORT POSITION
To change the machine from working
position to transport position, proceed
as follows :
- With the machine resting on the ground
and the tractor engine turned off,
disconnect the intermediate PTO shaft
(M) from the secondary gearbox and
secure with straps (O) (photo 4, page
10).
- Raise the FC 202 or FC 202 R to about
25 cm (10") above the ground.
- Lower lock (G) into the locked position
to secure the spring compensating system
(photo 24A).
- Standing at the right-hand side of the
machine, pull cord (E) to release lock
(F) (photo 15, page 13).
- Swing the unit to the rear until it
locks automatically into the transport
position (photo 25).
- Lock the pivot restraint (M) using the
locking pin (S) (photo 24B).
ALWAYS KEEP CLEAR OFF THE
MACHINE WHEN SWINGING THE MOWER
CONDITIONER INTO ITS TRANS-
PORT POSITION.
Never transport the machine on
the public highway when in the
working position, even over
short distances.
Never engage the PTO shaft of
the tractor when the machine
is in the transport position.
Using tractors smaller than 51
KW (70 HP), front ballast
weights should be used to
improve steering. For adequate
positive steering, there should
be at least 20% of the total
weight on the front axle.
Before taking the unit onto
the public highway, the
operator should make sure that
his machine conforms to the
highway code.
TRANSPORT AND PARKING POSITION