KUHN EL 92, Руководство по сборке и эксплуатации

Страница: 31 / 46

- 29 -
3) NYLON CLEANING PLATES FOR PACKER ROLLER SCRAPERS
Part no. 525 702 00 for the packer roller
These cleaning plates are made from a supple synthetic
material which enables them to be slightly pre
compressed against the roller for improved cleaning
action.
a) Installation and adjustment (photo 33)
The nylon cleaning craper plates (R) are to be placed :
- between two new standard steel scraper plates (S)
(525 321 30) for standard packer rollers by using a
longer screw (V) (part No 500 073 00).
Allow the nylon cleaning plate (R) to stick out of the carrier plates (S) by 10 mm and press it slightly against the
roller so that its leading edge is in contact with the roller segment across its full width. Rotate the roller one complete
turn to check that there is no gap between roller and nylon cleaning plate. Re-adjust the plate if this is not the case.
Also check that the upper carrier plate is set parallel to the roller segment and does not come into contact with it.
b) Use
The nylon cleaning plate is particularly recommended for light, loamy or chalky grounds with little crop residue or
stones. A correct cleaning plate adjustment results in a clean and shiny roller area across the full width of the
cleaning plates.
Soil deposit on the roller will result in premature cleaning plate wear. Readjust them quickly. The cleaning plate
is reversible for increased service life.
4) P.T.O. SHAFTS
The PTO shaft is available in the following versions to fit the tractor PTO :
- W 2500 1”3/8, 6 splines
:
part no. 4800 801
- W 2500 1”3/8, 21 splines :
part no. 4800 802
5) L-BLADES
part no. 519 215 00 : left L-blade
part no. 519 216 00 : right L-blade
The EL 92 are supplied with a rotor with C-blades.
L-blades are available through service parts department and can be fitted in replacement of C-blades.
The L-blades are recommended for work at a shallow depth.
6) SET OF PINIONS 21/25 TEETH
Kit no. 121 7070 (see page 18)
33