KUHN EL 92, Руководство по сборке и эксплуатации

Страница: 26 / 46

- 24 -
A) PACKER ROLLER : 2.05 m - Kit no. 121 7050
2.30 m - Kit no. 121 7060
This roller is particularly intended for use in wet or sticky soils. Efficient packing, proper levelling and good crumbling
are always achieved. Mud scrapers are an integral part of the packer roller. These scrapers, placed between the
rows of studs, ensure that the roller is cleaned.
a) Assembly of the packer roller and its scraper
When assembling the roller, take particular care concerning the direction of rotation. The direction of rotation is
indicated on the decal affixed to the side of the roller (see arrow, photos 24 and 25).
Using 8 bolts (U) and M 12 nuts and mount roller arms (B) and scraper bar arms (Z) on the bearing housings (T) placing
spacer (N) as shown on photo 24 (torque 10 daNm / 75 ft.lbs).
Then fit the swinging arms (A) on roller arms (B) with 6 bolts (C) (diameter 16 mm) (torque 22 daNm /
160 ft.lbs) (photo 25).
Then bolt the scraper bar (H) onto holders (Z) using the 4 screws (R) (photo 26). Do not fully tighten these bolts at
this stage. Check that all the cleaners (P) of the scraper are in the retracted position (photo 27).
Position the 2 eybolts (Q) (photo 26). Using the two nuts (S) tighten against the tensioners to pivot the scraper
towards the roller until the two elongated holes almost butt out (photo 26). Thereafter tighten the four bolts (R) (torque
22 daNm / 160 ft.lbs) and adjust the scraper plates (P) as described below.
Mount complete roller with roller arms (A) onto support yokes (K) using two pins (X) secured with 2 self-locking
screws (J) (M10x16). Make sure to fit spacers (D) (see photo 23, page 23).
24 25
26 27