KUHN AXERA-M, Руководство оператора

Страница: 30 / 46

30
♦
Set the other spreading side using the same metering slide position obtained, and
lock securely in place.
♦
After completing the calibration check, refit both discs.
♦
The right-hand disc (R) and left-hand disc (L) must be replaced carefully over
their corresponding drive hubs when viewing in the direction of travel. Make sure
both discs lie correctly on their drive hubs. Discs and vanes are indicated with (R)
and (L).
♦
Make sure the synthetic disc hub nuts are correctly fitted (not cross-threaded).
♦
Tighten synthetic disc hub nuts by hand.
♦
Reposition gearbox to the desired output point on both sides.
♦
Turn the spreading disc by hand to make sure discs and vanes turn freely without
fouling.
5. Removing unused fertilizer
To keep the spreader in good condition we recommend that all unused fertilizer is
removed immediately after field operations are completed. Follow instructions under
section 4.2 ( carrying out calibration check) to drain hopper. Use both left- and right-
hand shutter outlets. Any leftovers can be removed from inside the hopper with a
brush and pan.
6. Cleaning
To keep the spreader in good condition we recommend the unit be thoroughly clean-
ed with a low pressure water jet immediately after field operations are completed.
To simplify cleaning the hopper sieve can be removed.
When cleaning, make sure that the shutter control and shutter flow tracts are cleaned
from underneath.
Only wash in suitable areas specifically designed to collect and remove environmen-
tally damaging elements such as oil and fertilizer, without endangering the surround-
ing environment.
When washing with pressure washers, never direct the jet directly into any electrical
elements, on to warning decals, exposed hydraulic machine parts or exposed bear-
ings.
After drying off the spreader we recommend that it is treated with environmentally
acceptable biodegradable anti-corrosion liquid or spray. It is especially important to
treat the vanes.