KUHN AXERA-M, Руководство оператора

Страница: 13 / 46

13
2.3 Fitting the Tele-Space pto shaft (spreader side)
Only pto shafts supplied or recommended by the manufacturer should be used. The
fertiliser spreader is equipped with a pto shaft that corresponds to the implement's
technical characteristics and power requirements. It should not be replaced with
shafts with other specifications.
When first attaching the spreader to the tractor, the length of the shaft must be
matched and, if necessary, shortened to fit the tractor correctly.
Read the pto manufacturer's operator's manual carefully, taking special note of the
instructions concerning the shortening of the shaft. This operator's manual can be
found attached to the pto shaft.
If the pto shaft is too long, both pto drive and the spreader may be damaged when the
unit is raised.
The Tele-space pto shaft allows additional free room for easy coupling of the fertil-
iser spreader to the tractor.
DANGER
Fitting and removing the pto shaft (fertiliser spreader side)
Injury or death hazard due to rotating shaft.
•
Before fitting or removing the pto shaft, make sure that the cou-
pled spreader is secured by support blocks to avoid unintentional
lowering and that the tractor is choked to avoid unintentional
creeping.
•
Before fitting or removing the pto shaft, make sure that the pto
drive is disengaged, the tractor engine is switched off and the ig-
nition key is removed!
•
Always respect correct fitting and securing of the pto shaft. The end marked with
a tractor symbol must be fitted on the tractor side.
Remove the cover (1) from the bell protector
guard.
Fit the pto shaft onto the drive stub and secure in
place with the hexagon nut and bolt (2) and (3).